Shineworks Clay Towel — Polymer Rubber Clay | Reusable | 30cm x 30cm

Claying, Without the Clay Bar Hassle

The Shineworks Clay Towel changes how you approach decontaminating a car. It pairs modern polymer rubber technology with a premium microfibre cloth to lift bonded contamination safely and quickly across a whole panel instead of a palm sized patch. At 30cm x 30cm it covers ground fast, and unlike a clay bar, if you drop it you just rinse it off and carry on.

Glides on and off. Showroom smooth.

All stock in NZ ready to ship.

---

Features

• Polymer rubber face lifts bonded contamination without the drag and grab of traditional clay
• Lasts 4x longer than a clay bar, and a rinse brings it back
• 30cm x 30cm working area covers a panel in a fraction of the passes
• Fully reusable, with no kneading, no folding and nothing to throw away when it hits the driveway
• Safe on automotive paint, glass, rubber mouldings and plastics

---

What It Removes

• Paint overspray
• Tar
• Industrial fallout and iron
• Bird droppings and insect residue
• Tree sap and road dust
• Oxidation and water spots

---

How to Use

1. Thoroughly wash the vehicle to remove dust, sand and loose dirt.
2. Soak the clay towel in water and keep it wet throughout the job.
3. Work panel by panel with plenty of clay lubricant, using light pressure and straight passes.
4. Rinse the towel regularly as it picks up contamination.
5. Wash the vehicle again once you have finished claying.

---

Where to Use It

• Paintwork carrying fallout, overspray or rail dust
• Glass, rubber mouldings and plastic trim
• Before polishing, sealing or applying a ceramic coating

---

Care Instructions

• Rinse: Rinse thoroughly with clean water after every use.
• Store: Store clean and dry, away from grit and direct sunlight.
• Inspect: Check the face for embedded grit before each use.
• Avoid: Never use on a dry surface, and keep solvents away from the clay face.

---

Please Note

Plain water is not an adequate lubricant, so always use a dedicated clay lubricant. Do not use on surfaces below 12°C or above 60°C. The clay face is not solvent resistant, so remove tar and grease with a dedicated remover before claying.